The most active type of erosion in our regions, fluvial erosion is the action created by a river or stream. The eroded material is transported by the water and accumulates downstream (we call it deposit or sedimentation). A torrent is a river situated in mountainous regions with an irregular flow. It is very steep. Opposed to this are rivers which flow in the plains and have a weak slope. The efficiency of erosion depends on the slope. Torrents have a strong erosive power. A waterway acts in three ways: ablation or removal of rocks, transporting the eroded particles and deposition and accumulation of sediments.
River Landforms A river changes as it flows from its source to its mouth. Geographers usually divide it into three sections. The Upper Course The slope is steep, the valley is narrow and the river cuts downwards (vertical erosion).
V-shaped valleys: the river cuts down into the rock, while weathering and slope movements wear back the sides, giving the valley a V shape. Unlike glacial valleys, which are U-shaped, V-shaped valleys are typical of rivers.
Gorges: narrow, deep valleys with steep rock walls, where the river cuts through resistant rock. Examples: the Areuse gorges (NE) and the Aare gorge (Aareschlucht) near Meiringen, cut by the river through a rock bar left by the glacier.
Waterfalls: form where a river flows over a band of hard rock lying on top of softer rock. The softer rock is eroded faster, the hard rock is undercut and collapses, and the waterfall slowly moves back upstream, leaving a gorge behind it. Example: the Rhine Falls near Schaffhausen, the largest waterfall in Europe by volume of water. It formed around 15,000 years ago, when the Rhine was forced into a new bed after the last ice age.
The Middle Course The slope becomes gentler, the valley widens and the river begins to erode sideways (lateral erosion).
Meanders: large bends in the river. On the outside of the bend, the water flows fastest and erodes the bank, creating a steep river cliff. On the inside of the bend, the water is slower and deposits sand and gravel, creating a gentle slip-off slope (point bar). Over time, the meanders become increasingly pronounced.
Incised meanders: when the land rises or the river cuts down deeply, meanders can become trapped in a deep valley. Examples: the Sarine around Fribourg and the Doubs at Saint-Ursanne.
Oxbow lakes: when two meanders come very close, the river can cut through the narrow neck of land during a flood. The old bend is abandoned and becomes a crescent-shaped lake.
The Lower Course The slope is very gentle, the valley is wide and flat, and deposition dominates.
Floodplains: wide, flat areas on either side of the river, covered by water during floods. Each flood leaves a layer of fertile sediment, which is why floodplains are valuable for agriculture.
Levees: natural banks of sediment built up along the edges of the river during floods. They are often raised artificially to protect against flooding.
Deltas: form where a river deposits its sediments as it enters a lake or a calm sea, often splitting into several channels. Examples: the Rhône delta in Lake Geneva, the Maggia delta at Locarno, and the Nile and Mississippi deltas.
Estuaries: form where tides and currents carry the sediments away, leaving a wide, funnel-shaped river mouth. Example: the Thames estuary.
Human Impact: Correcting Rivers In the 19th and 20th centuries, many Swiss rivers were straightened and channelled to protect against floods and gain farmland. The best-known example is the Jura Water Correction, whose first phase took place from 1868 to 1891 and drained the large marshes of the Seeland. Today, many rivers are being re-wilded: they are given more space so that they can flood naturally and support biodiversity, as in the ongoing third correction of the Rhône in Valais.
Vocabulary: Corrasion or abrasion: the wearing away of the bed and bank by the load carried by a river. Attrition: the wearing away of the load carried by a river. Hydraulic action: the force of air and water on the sides of rivers and in cracks. Corrosion: the removal of chemical ions, especially calcium. Transport by Rivers A river carries its load in four ways, depending on the size of the particles and the speed of the water:
Traction: large stones and boulders are rolled or dragged along the riverbed. This mainly happens during floods, when the water is fast and powerful.
Saltation: pebbles and sand bounce along the riverbed in a series of small jumps.
Suspension: fine particles of clay and silt are carried within the water. This is why rivers look brown after heavy rain.
Solution: dissolved minerals, especially limestone, are carried invisibly in the water.
The faster the water flows, the larger the particles it can carry. When the river slows down, for example on a gentler slope, on the inside of a bend or where it enters a lake, it can no longer carry its load, and it deposits the largest particles first, then the finer ones. Unlike glaciers, rivers therefore sort their deposits by size.
Relevant exams: 2014b: True False Erosion p. 2 2019b: Erosion in temperate environment p. 5 2020b: The transformation of the earth’s crust under the action of water p. 4